Read the following passage and answer the question.
Mr. Verma is the factory manager of Shakti Engineering Works. He found that the supervisors on the shop floor could not do their job well, because no single supervisor had all the qualities that the job needed. He therefore divided the work of supervision among specialists. One group of specialists prepares instruction cards, decides the route of each job, keeps records of time and cost, and looks after rules and order. Another group sees that the work is done at the right speed, that machines and tools are ready and in repair, and that the finished work is checked for quality. Each worker now receives instructions from all these specialists, each in his own area.
Which technique did Mr. Verma apply, and who gave it?
Answer & explanation
Correct answer: option 2
The correct answer is Option (2) → Functional foremanship, given by F.W. Taylor
Option (1) Functional foremanship, given by Henri Fayol — Incorrect. Functional foremanship is right, but it was given by Taylor. Fayol gave the 14 principles of management.
Option (2) Functional foremanship, given by F.W. Taylor — Correct. Taylor found that no single person had all the qualities a good foreman needs. So he suggested functional foremanship through eight persons. Mr. Verma did the same by dividing supervision among specialists. It is a technique of scientific management.
Option (3) Method study, given by F.W. Taylor — Incorrect. Method study is Taylor’s technique for finding one best way of doing a job, as in the assembly line. Mr. Verma’s step is about supervision.
Option (4) Division of work, given by Henri Fayol — Incorrect. Division of work is Fayol’s principle of dividing work into small tasks done by specialists. Functional foremanship extends it to the shop floor, but the method Mr. Verma applied is Taylor’s technique.
A principle such as division of work is a broad guideline for decisions. A technique such as functional foremanship is a set method with definite steps.
NCERT (2026-27 Edition): “Functional Foremanship In the factory system, the foreman represents the managerial figure with whom the workers are in face-to-face contact on a daily basis. In the first chapter of the book, you have seen that the foreman is the lowest ranking manager and the highest ranking worker. He is the pivot around whom revolves the entire production planning, implementation and control. Thus, Taylor concentrated on improving the performance of this role in the factory set-up. In fact, he identified a list of qualities of a good foreman/supervisor and found that no single person could fit them all. This prompted him to suggest functional foremanship through eight persons. …” |